Bandmaster Blackface Mod Kit

Bandmaster Blackface Mod Kit

  • $30.00


Bandmaster (non-reverb) Blackface Mod Kit

This kit includes all of the electrical components, diagrams & written instructions you need to perform a full blackface conversion on your silverface Fender Bandmaster amplifier, converting it to the coveted AB763 specs!

(Sorry! Tools, solder & wire NOT included).

*Complete, detailed, easy to follow instructions with “before & after” diagrams are included.

*Copies of the original blackface Fender schematic & layout diagram for your amp are included! These are invaluable tools for reference & learning about your amp!

*Complete instructions for removing the master volume & push/pull gain boost are included.

*Only the highest quality Nichicon electrolytic capacitors are included in this kit.

*Only the highest quality carbon resistors are used in the signal path. Flameproof metal oxide resistors are used for the high voltage applications in the power supply & bias supply.

*Instructions for reading color codes on resistors included.

BONUS: Certain resistors, vital to optimum performance of the driver & phase inverter have been measured & matched by tolerance percentage!! You are getting a matched set for your output section! This ensures maximum efficiency, optimum performance and the best possible tone from your Fender!

PLEASE NOTE: Due to the current supply chain issues, and the announcement of planned obsolesce of carbon comp resistors by at least one of the few remaining manufacturers, we will be phasing in a high quality carbon film resistor in certain places in our kits as necessary.  These specific CF resistors are now considered to be NOS, made in Japan (the company has since relocated manufacturing to another country), and the best sounding modern CF resistor available (not to be found on any of the standard amp parts suppliers websites).  

We have stocked up on some absolutely VITAL carbon comp values, so we will be able to offer carbon comp in key places for a while yet, but the phasing out of these iconic components has begun.  We will use all of the carbon comps we have and buy more until no longer available.  Carbon film resistors will now be phased into out kits as availability dictates. 

The tolerance normally associated with resistors makes it almost impossible to find matched sets unless you have hundreds & hundreds to choose from, & the time to sort through them all.

We have taken readings on literally thousands of resistors and spent countless hours putting these matched sets together. Why? Because matched sets sound and perform better than unmatched! Most kits on the market today do not take the time to provide this important service.

As a bonus, the necessary resistors & detailed instructions on how to properly set the bias of your newly blackfaced amp (using only a multimeter & calculator) are included.

Please note:  These kits are designed for the “standard” Fender silverface amplifiers.  If your amp is “ultralinear”, these kits are not intended for your amp.  You can tell if your amp is ultralinear by looking under the speaker jack on the back panel.  ALL 70 watt & 135 watt models are ultralinear!!  

For UL amps, please check out out '1/2 blackface mod'